-01-01.png)
Setup Network Menu
To access the Network Menu:
1. From the Main Menu navigate to [4 - SETUP MENU]. Press [ENTER]
2. Within the Setup Menu navigate to [7 - NETWORK]. Press [ENTER]
1 - Network Enable
This menu sets the ETHERNET jack output on or off. If the jack is not needed, it can be turned OFF (default).
Use the arrows to toggle between ON/OFF and press ENTER to save.
Note: If this setting is set to OFF, all the menus below will be disabled.
2 - IP Address
This menu allows the operator to set or verify the IP address of the console. The default setting should be 192.168.0.55
In most cases, the standard IP address should be selected. Press [1] followed by [ENTER] and the display will verify the console’s IP address.
If a custom IP address is required, press [2] followed by [ENTER]. Press the [0]-[9] keys to enter a new value for each group of numbers and press [ENTER] after every group
3 - Subnet Mask
The subnet mask may only be edited if the IP address is set to custom. The default setting should be 255.255.255.0
Press the [0]-[9] keys to enter a new value for each group of numbers and press [ENTER]
after every group. If no change is needed, press [CLEAR] twice to exit the menu.
4 - Gateway Address
The gateway address may only be edited if the IP address is set to custom. The default setting should be 192.168.0.1
Press the [0]-[9] keys to enter a new value for each group of numbers and press [ENTER]
after every group. If no change is needed, press [CLEAR] twice to exit the menu.